Type
Special resin / One pack air drying.
Usage
Reverse printing on the flat surface plastics (PC, treated PET) to get mirror effect appearance.
Feature
Excellent mirror finish can be made by high brightness special aluminum flake
Good printability and high opacity is possible by single printing process
High viscosity ideal for printing.
Diluents
Standard T-477
Normally, diluents is not required but if necessary, use this solvent to restore the
viscosity to original condition.
Screen mesh
Polyester/Nylon 250~300 mesh/inch fabric and squeeze hardness 80 durometer is recommended.
Half mirror transparency can be adjusted by screen mesh size.
Drying
Initial drying at 50¡æx5~10 minutes before the forcing drying 80¡æ§·30 minutes is recommended.
Wash-up
T-16/T-16K
Others
•Printing conditions such as emulsion thickness, screen mesh size, drying condition, etc
are important factors to get the original performance of half mirror sliver. Which influences
the brightness and printing finish.
•Check the adhesion and printing finish on the substrate before printing due to variation with time.
Stir the ink well before the printing to avoid aluminum pigment agglutination
OSA ¨Cseries or PPT ¨Cseries are suitable for printing as a back- up.
|
